CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   how I can read two model files? (http://www.cfd-online.com/Forums/cd-adapco/55391-how-i-can-read-two-model-files.html)

moh May 22, 2006 06:08

how I can read two model files?
 
Hello

how I can read two model files in the same time using praom or prostar

thanks moh

TG May 22, 2006 08:38

Re: how I can read two model files?
 
you need to take 1 model file and write out all the geometry (cwriter,vwrite,bwrite,cpwrite...). Then close the session, resume the other model file and read in the various files with a big enough offset so they don't conflict (cread, vread,...)

moh May 22, 2006 09:35

For TG
 
thanks alot TG

but if i have two volumes shared with a baffle how i can let praom mesh the two vloumes togher without chane the baffle

thanks Moh

TG May 23, 2006 22:31

Re: For TG
 
Sorry - I don't know the answer to that one.


All times are GMT -4. The time now is 11:45.