heat source in starcd
 

hi friends, in my model one fluid region and four different solid regions are there. these solids having heat source 20,20,40,15 Watts respectively,volume is say a,b,c,d. how to apply these heat source to the solid regions. if you have any subroutine please mention that. thanks in advance. kiran kumar

Re: heat source in starcd
 

sorent.f

IF(ICTID.EQ.xxx) THEN S1p = ...... S2p = ...... ENDIF

easy eh

Re: heat source in starcd
 

You can define it also with a table (folder Source under folder Thermalphysical Models) and you have just to defin S1P. (always in W/m3, independent from the dimension of your geometry).

Re: heat source in starcd
 

Funny, I was having similar problem. Sorent.f was easy but the table was not so easy. I dont understand how to key into the table and what does "independent" mean in that table? Couldn't find tutorial on this one either.