CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   How could I build symmetrical mesh? (http://www.cfd-online.com/Forums/cd-adapco/55719-how-could-i-build-symmetrical-mesh.html)

josephlo December 3, 2006 06:22

How could I build symmetrical mesh?
 
I had some trouble. I used pro-modeler to creat the mesh. The model is a sphere in a rectangular. http://www.wretch.cc/album/show.php?...1304924795&p=0 I want to build mesh is symmetrical in right hand side and left side in the sphere. How could I build the symmetrical mesh? (I try to use STAR-CD to use symmetrical boundary condition in the half of the model, but it is not convergence. Because the symmetrical boundary condition must not have a gradient, I am so confused.)

THX

yacine December 9, 2006 04:47

Re: How could I build symmetrical mesh?
 
to do that just build the grid for half of the domain then use the star-cd command cvreflect. that will creat an indentical mesh on the second side.


All times are GMT -4. The time now is 02:22.