|
[Sponsors] |
June 9, 2021, 08:46 |
mass flow
|
#1 |
New Member
Stefan Krupp
Join Date: May 2021
Posts: 2
Rep Power: 0 |
hey guys,
here i have a pdf-doc with my results and scrennshots from a simulation. if i zoom out the element sizes i get a smaller velocity, but higher y+ values. (i think the velocity is too high..) how should i handle this? and what should i do to get the same mass flow at the inlet and the outlet. at the moment they are different... greetings |
|
August 2, 2021, 10:06 |
|
#2 |
New Member
UK
Join Date: May 2019
Location: uk
Posts: 25
Rep Power: 6 |
This is not FLOW-3D so you need to post in the correct forum.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 06:40 |
Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
Mass flow rate history over solution step- rhoSimpleFoam | gian93 | OpenFOAM Post-Processing | 0 | December 8, 2019 10:20 |
Inconsistencies in reading .dat file during run time in new injection model | Scram_1 | OpenFOAM | 0 | March 23, 2018 22:29 |
Mass Flow Inlet | Pravir Kumar Rai | FLUENT | 0 | February 19, 2003 14:03 |