Save User Data
 

Hi,

I have a problem when saving user data with StarCD 3.26.

I defined a cell set containing 10800 cells (that's what it is found using the Cell List or Cell Check commands in the Cell Tool utility). If I try to save to file data for this cell set (using Post > Save User Data), the resulting file contains only 10752 cells!

Where are the other 48 gone? Where could the problem be?

Thank you very much in advance,

Ale

Re: Save User Data
 

check to see if any cells in that cset are not fluid (ie baffles, shells, or solid cells). It won't write data for those.

Re: Save User Data
 

Thank you for your reply.

However, I defined the cell set using the command 'cset' (cset news type table#), and I loaded only one fluid cell table. Also the command 'count cells' confirms that there are 10800 fluid cells in the set, but in the file I get only 10752 cells... I still don't understand this.

Thanks a lot anyway.

Regards,

Ale

Re: Save User Data
 

try to type:

close all

other:

close filename.usr

Re: Save User Data
 

Thank you, Nahum.

I tried this with no success. I tried to close all files (but then I must reopen the pst file) and to close the usr file, but the issue still happens (even if the generation of the user data file is the first thing I do after opening the mdl file and loading the pst file).

I will keep on looking for the origin of this problem. Thank you anyway for your support,

Ale

Re: Save User Data
 

Hi, I have found that the number of cells saved in the file is always a multiple of 256: it is the largest multiple of 256 lower than the number of cells in the set.

Any clue?

Thanks,

Ale