CCM+ Interface - Merging Boundaries

June 18, 2007, 13:50

I have two boundaries on two regions that are exactly the same (one was created from the other using the cavity feature in SolidWorks). But for some reason CCM+ cannot merge them together, stating that it cannot match up the perimeters of the boundaries. I have over 200 other boundaries, created in the same way, that merge fine but for some reason these two will not.

I have isolated the problem faces and they are exactly the same. Has anyone seen this probelm before and if so, how did you get around it?

June 19, 2007, 13:57

hi..

delete one of them then try to create interface by right clicking on remaining boundary and selecting the Convert to Interface option..

then tru zipping edge and go on...

June 18, 2007, 13:50	CCM+ Interface - Merging Boundaries	#1
Alex Guest Posts: n/a	I have two boundaries on two regions that are exactly the same (one was created from the other using the cavity feature in SolidWorks). But for some reason CCM+ cannot merge them together, stating that it cannot match up the perimeters of the boundaries. I have over 200 other boundaries, created in the same way, that merge fine but for some reason these two will not. I have isolated the problem faces and they are exactly the same. Has anyone seen this probelm before and if so, how did you get around it?

June 19, 2007, 13:57	Re: CCM+ Interface - Merging Boundaries	#2
Nari Guest Posts: n/a	hi.. delete one of them then try to create interface by right clicking on remaining boundary and selecting the Convert to Interface option.. then tru zipping edge and go on...

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
merging the meshes	Virag	CFX	2	March 5, 2007 06:41
Merging volumes???	Kiran	FLUENT	4	May 18, 2006 04:46
vortices merging	bin	FLUENT	0	March 6, 2005 23:48
Merging and Uniting	Theju	FLUENT	0	February 28, 2002 06:10
Merging Meshes	Matteo Giacobello.	FLUENT	1	February 16, 2000 09:22