|
[Sponsors] |
July 24, 2007, 14:32 |
ERD file
|
#1 |
Guest
Posts: n/a
|
I am modeling creeping flow. When I save the .erd file for mass flux, the value is so small that the file reads zero. Is there a way to change the resolution?
|
|
July 25, 2007, 08:31 |
Re: ERD file
|
#2 |
Guest
Posts: n/a
|
File *.erd contains only zero in mass column? Or registers equal zero when you upload *.erd? If the first is right i think, you can't do anything. If the second is right, you may try solve problem with scale factor. In that way starcd can use scaled number.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PLOT3D ASCII solution file to MATLAB data file | Sandeep Rana | Main CFD Forum | 4 | June 11, 2010 09:48 |
[OpenFOAM] ParaView exiting while trying to save image file or movie file | 21kalee | ParaView | 3 | January 23, 2008 16:01 |
Changing gambit file without change of case file?? | Asghari | FLUENT | 2 | August 28, 2006 13:48 |
Covert gambit file to polyflow file | John | FLUENT | 5 | August 6, 2004 08:31 |
Converting a surface file to a volume file | Amir | FLUENT | 2 | December 30, 2002 04:53 |