|January 17, 2008, 02:00||
selection of individual cells (not cell faces)
Wish you happy new year ..
In STARCCM+ how can i select trimmed cells individually or by zone...Because i need to give boundary condition for some of the cells located in cell face(not entire cell face).
For better understanding i am giving example,,
If my cellface length is 100 mm & width is 200 mm from which i have to select 50*100 size of face ..please advice me ,,,,,
Thanking you all....
|Thread||Thread Starter||Forum||Replies||Last Post|
|flux through individual cells / face areas||Mike||FLUENT||2||February 16, 2009 11:43|
|Plot Y+ vs individual cell||Anhkien||FLUENT||4||December 3, 2007 09:07|
|Reporting pressure at individual cell faces||Shank||FLUENT||0||September 11, 2007 12:24|
|Beginner: cell faces of surface cells||Sunlight007||CD-adapco||0||August 24, 2003 17:19|
|volume of individual cell||Jan||CFX||1||May 16, 2003 07:09|