CCM+: Surface Wrapping Tutorial
Hi, has anybody seen a tutorial or something like that to test how the surface wrapper is working? Strange to have such an nice feature but no chance to test it without reading the tutorial guide (hard work).
Regards Peter |
Re: CCM+: Surface Wrapping Tutorial
CD-adapco are hammering on about the wrapper fairly hard at the moment so I reckon if you were to e-mail them they should be able to send you one.
|
Re: CCM+: Surface Wrapping Tutorial
CD-adapco Germany has no tutorial for s. w.
|
Re: CCM+: Surface Wrapping Tutorial
CD-adapco UK has one - strange?!
|
Re: CCM+: Surface Wrapping Tutorial
This is probably because the suface wrapper is developed in the UK.
|
Re: CCM+: Surface Wrapping Tutorial
No it was developed in the US where all the meshing products have been developed.
|
Re: CCM+: Surface Wrapping Tutorial
CD-adapco (in Germany, the UK, the US) have surface wrapping tutorials, you just need to ask the support team. There is certainly one based around this demo:
http://www10.mcadcafe.com/link/displ...?link_id=22857 To be honest, the surface wrapper is simple enough that you can start using it on your own geometries without too much difficulty Stephen\ |
Re: CCM+: Surface Wrapping Tutorial
To be honest, the surface wrapper is very complex. But in the next Version (3.xx) is a tutorial in the user guide. I have it now. To be honest: very, very complex but fantastic. Fluent (Ansys) should put on warm clothes ;-)
Peter |
Re: CCM+: Surface Wrapping Tutorial
What is obvious to some is baffling to others.
|
Re: CCM+: Surface Wrapping Tutorial
> Fluent (Ansys) should put on warm clothes ;-)
Really? I know both of the wrappers, ccm+ up to v2.08 and FLUENT (TGrid 5.0) and in my eyes there is no doubt about that Fluent has the better one.... Regards |
All times are GMT -4. The time now is 08:02. |