CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   post process to get an arbitrary face data (http://www.cfd-online.com/Forums/cd-adapco/56472-post-process-get-arbitrary-face-data.html)

oniboy February 27, 2008 01:22

post process to get an arbitrary face data
 
Good day. I want to use post register operation to get data, and I ran a simple case about two metal layer pure conduction. The goal is temperature data distribution in the interface, so I set a shell on the interface.

I clicked the fuction button=> load boundary data => temperature=> got vales in column register 4. My question is.. Can I specify "one" boundary and only get this boundary region data?

And after I did steps described above, three another shell appeared in the cell table, symmentry shell, wall shell, nonwall shell, respectively. However, I checked the cell numbers corresponding to register4 in the register list, they are cell numbers of symmentry shell in the cell list.

I am very confusing because the three shells does not really exist.

How can I get the temperature in the interface ??


Jim February 27, 2008 12:44

Re: post process to get an arbitrary face data
 
bset news regi xxx vset news bset cset news vset all wplo


oniboy February 28, 2008 23:12

Re: post process to get an arbitrary face data
 
Thank you so much sir..

I think I got the tip to specify the vertex..



All times are GMT -4. The time now is 19:26.