|February 27, 2008, 01:22||
post process to get an arbitrary face data
Good day. I want to use post register operation to get data, and I ran a simple case about two metal layer pure conduction. The goal is temperature data distribution in the interface, so I set a shell on the interface.
I clicked the fuction button=> load boundary data => temperature=> got vales in column register 4. My question is.. Can I specify "one" boundary and only get this boundary region data?
And after I did steps described above, three another shell appeared in the cell table, symmentry shell, wall shell, nonwall shell, respectively. However, I checked the cell numbers corresponding to register4 in the register list, they are cell numbers of symmentry shell in the cell list.
I am very confusing because the three shells does not really exist.
How can I get the temperature in the interface ??
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to create an contour plot for arbitrary plane with interpolated data||navaladi||OpenFOAM Paraview & paraFoam||0||June 4, 2008 07:57|
|Need a post-process software||Munikrishna||Main CFD Forum||3||November 27, 2006 14:45|
|how to post process with visual3||dell||CD-adapco||2||December 17, 2002 02:59|
|Post-process: how to extract Graph Registers' data||Jiaying Xu||CD-adapco||11||July 17, 2002 04:38|
|200 data files to post process (how?)||Mark R||FLUENT||1||August 9, 2001 13:35|