CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > Siemens

Cross-Section

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   March 4, 2008, 10:35
Default Cross-Section
  #1
sidd
Guest
 
Posts: n/a
Can i measure the cross-section area at some arbitrary section defined interactively, in prostar?? If so, please let me know how?
  Reply With Quote

Old   March 4, 2008, 13:26
Default Re: Cross-Section
  #2
James
Guest
 
Posts: n/a
I would suggest the command INTEGRATE as in INTE CSET. This gives a variety of things including area. If you load in getc all dens it will give you mass flowrate (not as good as using fluxes but typically pretty close).

Do not put the section line on the edge of a large number of cell faces as it will double count cells from each side. For an arbitrary cut on an arbitrary mesh you should be fine.
  Reply With Quote

Old   March 10, 2008, 05:14
Default Re: Cross-Section
  #3
Sidd
Guest
 
Posts: n/a
Thank you James. This process needs me to run a case and then check for area, but what if i want to check the area first and then do some changes for case run.

I guess there is some command to extract the 2D shell of a section ALL mode. But i dont't remember. Could somebody help me.
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Velocity value at a Cross-Section??? Umm.. FLUENT 6 February 17, 2008 11:07
cross section visualization Nelly FLUENT 3 January 24, 2007 08:51
cross section average Paul FLUENT 0 April 12, 2006 12:30
Cross section 3d mesh nic CFX 4 March 14, 2004 06:59
variable cross-section Zsolt Ulbert Main CFD Forum 3 January 15, 2003 08:59


All times are GMT -4. The time now is 07:38.