CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   could some one tell me how to use command"CSHELL" (http://www.cfd-online.com/Forums/cd-adapco/56521-could-some-one-tell-me-how-use-command-cshell.html)

oni March 17, 2008 00:43

could some one tell me how to use command"CSHELL"
 
Hi all I used STAR CD4.02.

Proam manual wrote "If the shells in question have not been created in pro-STAR but have been imported from external sources, it is important to associate them first with their adjacent fluid cells. The association operation may be performed using command CSHELL." .

Shells in my cell table are no.2 and no.3 . Fluid is no.4 .

I inputted CSHELL => all

but it did not work.

Messages on the prostar out:

MESH*> cshell

ENTER ICTID, NC1(1),NC2(NC1),NCINC(1)

CSHE*> all

43456 BAFFLES AND SHELLS FOUND

0 BAFFLES AND SHELLS ASSOCIATED WITH FLUID CELLS IN THE RANGE

Could someone help me? Thanks :)


Balduin Bankerotti March 17, 2008 03:08

Re: could some one tell me how to use command"CSHE
 
There was a bug with the cshell command in one of the earlier prostar-v4 versions. Try it with the latest version (v404_12).

oni March 17, 2008 04:10

Re: could some one tell me how to use command"CSHE
 
Sigh.. I think there 's a bug in export mapped data to ABAQUS too.

When I selected Map Wall Data button,the segmentation fault appeared.


oni March 17, 2008 05:18

Re: could some one tell me how to use command"CSHE
 
If I want to associate the shell with the fluid and make couples between them..

Should I create another shell in the cell table

and add the new shell on the fluid surface that I want to make couples with original one..

Finally use CSHELL to make couples between original shell and the new shell ?

Thanks !!

Pauli March 17, 2008 16:33

Re: could some one tell me how to use command"CSHE
 
Your description indicates you are using the command incorrectly.

You entered cshell,all. The command should be cshell,ictid,all.


oni March 17, 2008 22:31

Re: could some one tell me how to use command"CSHE
 
Thank you very much, Pauli.

But after I knew how to enter correctly, I tried "CSHELL

ICTID CSET".

It still did not work. :)

Pauli March 17, 2008 23:01

Re: could some one tell me how to use command"CSHE
 
You need to replace ICTID with the shell ctype.

At the command line enter "help cshell" & follow the instructions.

oni March 20, 2008 06:05

Re: could some one tell me how to use command"CSHE
 
Thank you again for your advice.


All times are GMT -4. The time now is 09:25.