|July 31, 2008, 23:36||
Evaporation/Condensation in StarCCM?
Hi, I'm currently using starCCM+'s multiphase model to model a thin film of water flowing down a vertical flat plate (with an air/water interface), and have successfully achieved this.
The next step in my project is to add a heat flux through the plate and model the evaporation of the water into the air. Does anyone know if StarCCM is capable of this?
I can't find anything in the help function about evaporation from heat transfer, only phase change due to cavitation. If anyone knows anything about this I would greatly appreciate the help!
|March 25, 2010, 14:04||
Naimish Harpal (MS Aerospace Engr)
Join Date: Jul 2009
Location: Long Beach, CA
Posts: 50Rep Power: 8
If you are using Lagrangian Multiphase model together with evaporation model, then you can define/set your Boundary condition like either Escape/Rebound/Evaporate. Chose 'Evaporate' and set respective parameters.
I hope that it will help you.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Can Fluent perform evaporation and condensation simulation?||Wei Shao||FLUENT||23||February 18, 2016 03:56|
|Water Evaporation and condensation modeling||Linjie||FLUENT||4||February 18, 2016 03:43|
|Evaporation and condensation in a tube||Wei Shao||Main CFD Forum||4||September 16, 2009 10:19|
|A tutorial for condensation or evaporation||Asghari||FLUENT||0||September 29, 2006 22:25|
|evaporation and condensation in the VOF model||Glev||FLUENT||0||December 24, 2004 05:55|