CFD Online Logo CFD Online URL
Home > Forums > CD-adapco

inner interface

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   November 11, 2008, 07:01
Default inner interface
Posts: n/a
Hi , I have defined two regions while creating geometry and then have imported it into starccm+. I need two define the inner interface where the two regions join each other. both are fluid regions. when i try to convert the face to inner interface it creates a copy as well. now I have one face and one copy in each region all together four where I need only two. any hint please??
  Reply With Quote

Old   November 11, 2008, 08:05
Default Re: inner interface
Posts: n/a
I am getting the following message when i try to generate volume mesh.

An edge attached to Boundaries: Face 5, device is attached to an odd number of faces (3). Check surface and interface definitions on these boundaries before proceeding.:

  Reply With Quote

Old   November 11, 2008, 14:45
Default Re: inner interface
Posts: n/a
Delete whatever copies and interfaces you already created.

Select the two interfaces needed (one from each region), do "Create Interface", "In-Place".

"Convert to interface" should be used if you don't have separate regions already set up. Otherwise, use "Create Interface"
  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
2d interface Rogerio Fernandes Brito CFX 2 July 26, 2008 12:25
interface rym FLUENT 2 January 16, 2008 05:55
About Interface BC Philip FLUENT 0 January 3, 2008 02:51
How to set BC at the interface K Tamemy FLUENT 0 June 5, 2006 10:45
interface braket FLUENT 1 November 15, 2005 02:58

All times are GMT -4. The time now is 01:33.