CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > Siemens

from wrapper to remesher.... worse???

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   November 17, 2008, 06:03
Default from wrapper to remesher.... worse???
  #1
Jessica
Guest
 
Posts: n/a
hi all, i am using STAR-CCM+ and doing an analysis on some car bodywork and intake to air box geometry. i have a fantastic surface wrapper mesh, it's quite nice. when i run the remesher it is significantly worse. I have the wrapper scale factor at 50%, but i thought that the remesh worked off of the wrapper mesh, no? should i be using 100% and putting my base value as lower? i have refined the mesh in these areas.

any advice welcome!!! cheers, jess
  Reply With Quote

Old   November 17, 2008, 11:03
Default Re: from wrapper to remesher.... worse???
  #2
Jessica
Guest
 
Posts: n/a
all good, adjusted the regional settings, then created some volumes to further refine the mesh, and bingo!
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Tgrid wrapper surface Sam FLUENT 4 September 8, 2008 02:58
CCM+ Surface Wrapper Export Ross Kippenbrock Siemens 2 July 29, 2008 15:27
Parallel convergence worse than serial! Michael B FLUENT 3 December 9, 2006 22:46
Surface Wrapper Zamir Rashid CFX 0 September 18, 2006 12:04
surface wrapper carno Siemens 2 February 10, 2005 05:34


All times are GMT -4. The time now is 11:22.