|January 19, 2009, 16:16||
DFBI, turbulence model and ship motion
I've tried to run a simulation for ship motion (sink and trim). With the DFBI module, implicit unsteady, LAMINAR, I've got the ship motion attitude, but if I want to calculate Hydrodynamic forces I need a turbulence model. When I switch from LAMINAR to TURBULENCE (k-w SST or k-e), mesh with the correct boundary layer (y+=50),the simulation diverges and the free-surface at VOF=0,5 of water or air is very bad and unphysical.
Has anybody any idea to solve this question?? Why with lamiar model the simulation is ok and with turbulent one not??
I'm very interested in solving ship motion and hydrodynamics forces at the same time.
Thanks a lot. e.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Info on DFBI for Ship Motion||Simone||CD-adapco||16||November 20, 2015 13:58|
|turbulence model for ship hydrodynamics||ettax||CD-adapco||0||January 20, 2009 06:02|
|Simulation for ship rolling motion in Fluent?||VU THUAN||FLUENT||3||August 12, 2008 20:49|
|Ship motion||Yasser||CFX||1||June 5, 2007 15:59|
|Application of FEM for Ship Motion in Harbours||Suhas Thakurdesai||Main CFD Forum||0||October 31, 2003 04:31|