CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   a question about Starccm+ (http://www.cfd-online.com/Forums/cd-adapco/56972-question-about-starccm.html)

Wei January 27, 2009 05:28

a question about Starccm+
 
Hallo everyone:

How i can choose one cell, which i want it,in Starccm+ just like in Starcd.

I want to watch the cell during the Calculation.

Thanks a lot

Ola January 27, 2009 05:39

Re: a question about Starccm+
 
Under Representations/Volume mesh/Cell sets you can create a cell set and manually select a cell using the zone tool in your scene or if you know the cell number through a cell list. Just as in Prostar you can work with subsets and whatnot.

Good luck

Andrea January 27, 2009 06:20

Re: a question about Starccm+
 
You can also obtain the cells you want to look by a derived part object, using cell number, cell centroid location, etc...

Wei January 27, 2009 06:50

Re: a question about Starccm+
 
How can i know the each cell Number?

adsfg January 27, 2009 12:54

Re: a question about Starccm+
 
I think it is more likely that you just want to monitor a certain point. Monitoring a cell is not how this is done in Star-CCM+. You should use a point probe with a maximum report.


All times are GMT -4. The time now is 05:45.