CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CD-adapco

Diesel combustion simulation ( Heat release rate)

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   February 25, 2009, 06:40
Default Diesel combustion simulation ( Heat release rate)
  #1
venkatesh
Guest
 
Posts: n/a
I have one doubt in starCD regarding the heat release, when I do Combustion simulation of Turbocharged diesel engine using StarCD V3.26

When I use enthalpy option (Thermal models) as "Chemico thermal" , I am not getting heat release rate values in spd.01 file.(At every crank angle during combustion period, heat release values are plotted as zero in spd.01). Since combustion involves chemical reaction, I am using "chemico thermal" option as suggested by many people.

If I use enthalpy option as "Thermal", I am getting heat release rate values. But Maximum temperature values at TDC ~2900k & average temperature inside the cylinder at TDC is 1450k. So Nox values obtained from StarCD are also higher than experimental values.

But When I use enthalpy option as "Chemico thermal" I am getting maximum temperature value at TDC below 2400k which is acceptable. Only problem when I use "Chemico thermal" is, I am not getting heat release rate values at every crank angle.

Is there is any other switch is available in Starcd 3.26 version to get heat release value? Or kindly request you to suggest me the procedure to get heat release rate values when I use "Chemico thermal" option.

Thanks in advance

  Reply With Quote

Old   March 16, 2009, 01:47
Default contact CD-adapco local support
  #2
New Member
 
Join Date: Mar 2009
Posts: 2
Rep Power: 0
kat123 is on a distinguished road
Hi Venkatesh

try to contact ur local cd-adapco office for more assistance on this issue
kat123 is offline   Reply With Quote

Old   April 29, 2009, 07:38
Default
  #3
New Member
 
mosheu
Join Date: Apr 2009
Posts: 14
Rep Power: 8
hkoten is on a distinguished road
hi Venkatesh
which comb model do you use for diesel
can I use EBU for diesel combustion
did you close cfm or ecfm models in esice
hkoten is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
heat release rate calculation Karthick .K FLUENT 1 February 27, 2014 20:55
Troubles with heat release rate Xavier Ponticq CFX 4 September 12, 2012 18:49
Non-premixed combustion: local heat release rate LB FLUENT 0 September 3, 2007 12:58
heat release rate simulation chiang CD-adapco 8 April 16, 2006 07:47
calculation of heat release rate paul CD-adapco 3 February 16, 2006 04:40


All times are GMT -4. The time now is 23:07.