 |
 |
 |
|
|
|
[Sponsors] | ||||
May 29, 2009, 11:06
|
Option Rothalpy in Star CD
|
#1 |
|
New Member
amate
Join Date: May 2009
Posts: 1
Rep Power: 0  |
Actually, im modelling a part of centrifugal compressor with a blade of impeller and a vanless diffussor. I've chosen the option " conservation of rothalpy" for thermal model and "Implicit multiple rotating frames". But I 've obtained a wrong results of temperature: temperature at outlet is smaller than one at inlet. It's unphysical.
Some one of you can give me an advice in this case? |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Simulation of a single bubble with a VOF-method | Suzzn | CFX | 18 | October 2, 2009 04:18 |
| Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
| about compresive phase | James | CFX | 10 | September 12, 2006 03:16 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
| Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ... | 2 | July 15, 2005 04:15 |
Linear Mode
