Average velocity at pipe exit

bridgeovertroubledwater · January 3, 2019, 16:23

Hello this is probably a very simple question but if I wanted to look at the average velocity at a pipe exit would I create a plane at the exit and then plot the average velocity at that plane?
Would that work?
Thanks I’m quite new to ccm+ and cfd in general so sorry if it’s basic

bluebase · January 10, 2019, 04:42

Hi Becky,

as a general suggestion: work through the provided tutorials when you start with a new tool! It's not wasted time.

To get the average velocity at the exit you would need to create a new report, a mass-flow report. As part select the exit boundary.

Alternatively, you could create a mass-flow-averaged report over the velocity vector in outflow-boundary-normal direction.

After creating a new report you can open the context menu (right click) on such report and add a monitor and plot.

If any terms are unclear search the StarCCM help, or ask again.

Best regards,
Sebastian

January 3, 2019, 16:23	Average velocity at pipe exit	#1
bridgeovertroubledwater New Member Becky Join Date: Dec 2018 Posts: 7 Rep Power: 7	Hello this is probably a very simple question but if I wanted to look at the average velocity at a pipe exit would I create a plane at the exit and then plot the average velocity at that plane? Would that work? Thanks I’m quite new to ccm+ and cfd in general so sorry if it’s basic

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
IntegrateVariables in paraview to get a average flow velocity	Qihao	OpenFOAM	15	October 30, 2019 18:55
Average velocity of two different planes	niqbal	OpenFOAM Post-Processing	6	June 19, 2017 06:08
Area Weighted Average Velocity is Not Correct	CaptainCombo	FLUENT	1	April 24, 2017 15:18
Average Rising Velocity as boundary condition	Floing	CFX	11	August 21, 2016 05:47
VELOCITY vs VELOCITY IN STN FRAME vs RELATIVE VELOCITY	everest20	FLUENT	1	July 13, 2015 08:35

January 10, 2019, 04:42		#2
bluebase Senior Member Sebastian Engel Join Date: Jun 2011 Location: Germany Posts: 566 Rep Power: 20	Hi Becky, as a general suggestion: work through the provided tutorials when you start with a new tool! It's not wasted time. To get the average velocity at the exit you would need to create a new report, a mass-flow report. As part select the exit boundary. Alternatively, you could create a mass-flow-averaged report over the velocity vector in outflow-boundary-normal direction. After creating a new report you can open the context menu (right click) on such report and add a monitor and plot. If any terms are unclear search the StarCCM help, or ask again. Best regards, Sebastian