CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   mapping flat surface to curve surface (http://www.cfd-online.com/Forums/cd-adapco/65517-mapping-flat-surface-curve-surface.html)

wei June 17, 2009 09:49

mapping flat surface to curve surface
 
Do you have any idea how to map a flat surface with tetrahedral cell to a curve surface with hexahedral cell?

There is a small gap between these two surface. What commands should I use?

A_Lyaskin June 23, 2009 07:49

VPROJECT, I suppose. You'll also need to create shells at "target" surface before using it

wei June 26, 2009 08:10

thank you. i use 'vproj' to project the vertices to the surface. it works.


All times are GMT -4. The time now is 14:55.