Always the same results !

sheintz · March 30, 2010, 04:13

Hi,
i'm trying to simulate a spray injection in a chamber, I must analyse the depth of penetration and the cone angle of the spray. I vary differents paranmeters : injection pressure, chamber pressure, hole diameter, temperature, ...
I have different macro for the cone angle calculation and for the depth of penetration calculation.
But I have always the same results. Why ?
Thank you
Best regards

pkt109 · April 14, 2010, 14:55

Which Starccm+ version are you using?
Can you explain your problem more. How are you inputing your spary angle?

sheintz · April 15, 2010, 02:57

Hi,
I'm with StarCD 3.26. But I´have found the solution : after the PreProcessing I have to save my work and write the geometry fiel and the problem file because I star the job of a server.
I hope it can be usefull for someone else.
Best regards
Simon

sheintz · April 28, 2010, 03:34

The solution is :
I had to write the problem files and the geometry files because I work of a cluster (server) and not direct of star-cd.

March 30, 2010, 04:13	Always the same results !	#1
sheintz Member Heintz Simon Join Date: Sep 2009 Location: Germany Posts: 36 Rep Power: 5	Hi, i'm trying to simulate a spray injection in a chamber, I must analyse the depth of penetration and the cone angle of the spray. I vary differents paranmeters : injection pressure, chamber pressure, hole diameter, temperature, ... I have different macro for the cone angle calculation and for the depth of penetration calculation. But I have always the same results. Why ? Thank you Best regards

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OpenFOAM - Validation of Results	Ahmed	OpenFOAM Running, Solving & CFD	9	June 22, 2011 18:59
Different Results from Fluent 5.5 and Fluent 6.0	Rajeev Kumar Singh	FLUENT	6	December 19, 2010 11:33
wind tunnel results vs fluent	pixie	Main CFD Forum	1	August 20, 2009 08:02
Problems with repeating results	Lee	CD-adapco	4	May 26, 2006 03:39
benchmark results	stefan	CD-adapco	3	September 10, 2001 09:48

April 14, 2010, 14:55		#2
pkt109 New Member Join Date: Apr 2010 Posts: 3 Rep Power: 5	Which Starccm+ version are you using? Can you explain your problem more. How are you inputing your spary angle?

April 15, 2010, 02:57		#3
sheintz Member Heintz Simon Join Date: Sep 2009 Location: Germany Posts: 36 Rep Power: 5	Hi, I'm with StarCD 3.26. But I´have found the solution : after the PreProcessing I have to save my work and write the geometry fiel and the problem file because I star the job of a server. I hope it can be usefull for someone else. Best regards Simon

April 28, 2010, 03:34		#4
sheintz Member Heintz Simon Join Date: Sep 2009 Location: Germany Posts: 36 Rep Power: 5	The solution is : I had to write the problem files and the geometry files because I work of a cluster (server) and not direct of star-cd.