|
[Sponsors] |
January 7, 2011, 04:03 |
mrf doesn't work
|
#1 |
New Member
armansyah
Join Date: Oct 2010
Posts: 2
Rep Power: 0 |
hi,
my mrf model does not work, I use multiple frame-implicit method. this is occur when I apply inlet boundary. in the output file there are some "warning 003 (fluid inflow detected)". but if i modeling my case without inlet boundary no problem with my mrf, mrf successfully modeled. thank you for your response |
|
April 1, 2011, 18:46 |
|
#2 |
New Member
ara
Join Date: Apr 2011
Posts: 8
Rep Power: 15 |
if you are just modeling MRF, then you should have 3 regions, region 1 would be where you specify the inlet condition, interface the other end to the upstream of the MRF, and then interface the downstream to the third region where at the end it pressure outlet.
good luck. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Should an empty MRF zone really induce this much cross-flow? | sylvester | OpenFOAM | 5 | November 18, 2010 03:48 |
How to work with constant pressure? | Martin | Siemens | 2 | February 25, 2009 13:23 |
Getting FoamX to work | shaun | OpenFOAM Installation | 12 | March 23, 2007 08:55 |
Why do the Plant library cases don't work? | Alumna | Phoenics | 6 | June 22, 2004 12:08 |
why my In-Form doesn't work? | green | Phoenics | 2 | May 27, 2004 21:03 |