CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CD-adapco (
-   -   Informations needed about Moving Wall (

AdrienL August 3, 2011 06:13

Informations needed about Moving Wall
1 Attachment(s)
Hi all,

Has anyone information about the moving wall (real displacement) in Star CCm+ because there aren't much information in the Starcc+ Help.

My problem is shonw in the attached picture.

Thanks a lot for all your answer.


Maddin August 5, 2011 15:25

Read the other topics about this.
Run 5 steps, change mesh, remesh and 5 steps again etc... ;)

AdrienL August 5, 2011 17:27

The only way in CCM+ is the remeshing ??? it's was my first idea but it's way to long to remesh every 5 steps ...

ping August 15, 2011 21:38

you should use motion type Morphing for this case - very easy - read the help and do the training guide on this subject. You would only need to remesh if the red box gets too close to the blue box.
I suggest you post to the STAR-CCM+ forum in future.

All times are GMT -4. The time now is 19:12.