Informations needed about Moving Wall

AdrienL · August 3, 2011, 06:13

Hi all,

Has anyone information about the moving wall (real displacement) in Star CCm+ because there aren't much information in the Starcc+ Help.

My problem is shonw in the attached picture.

Thanks a lot for all your answer.

Adrien

Maddin · August 5, 2011, 15:25

Read the other topics about this.
Run 5 steps, change mesh, remesh and 5 steps again etc...

AdrienL · August 5, 2011, 17:27

The only way in CCM+ is the remeshing ??? it's was my first idea but it's way to long to remesh every 5 steps ...

ping · August 15, 2011, 21:38

you should use motion type Morphing for this case - very easy - read the help and do the training guide on this subject. You would only need to remesh if the red box gets too close to the blue box.
I suggest you post to the STAR-CCM+ forum in future.

August 5, 2011, 17:27		#3
AdrienL Member Adrien Lemoine Join Date: Jun 2011 Location: Paris,France Posts: 31 Rep Power: 2	The only way in CCM+ is the remeshing ??? it's was my first idea but it's way to long to remesh every 5 steps ... __________________ ------------------------------------------- Plz add reputation if the answer is correct A cœur vaillant rien d'impossible ------------------------------------------

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wall function for DPM needed	AMusteykis	FLUENT	0	January 13, 2010 15:02
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30
moving wall and fluid	soody	FLUENT	3	September 20, 2004 01:37
How to use UDF to define a moving wall	lingo	FLUENT	2	April 23, 2004 02:38
Values of k & epsilon in the moving wall	ghlee	Main CFD Forum	1	August 16, 1999 12:42

August 5, 2011, 15:25		#2
Maddin Senior Member Join Date: Mar 2009 Posts: 203 Rep Power: 6	Read the other topics about this. Run 5 steps, change mesh, remesh and 5 steps again etc...

August 15, 2011, 21:38		#4
ping Member Ping Join Date: Mar 2009 Posts: 78 Rep Power: 5	you should use motion type Morphing for this case - very easy - read the help and do the training guide on this subject. You would only need to remesh if the red box gets too close to the blue box. I suggest you post to the STAR-CCM+ forum in future.