 |
 |
 |
|
|
|
[Sponsors] | ||||
April 29, 2011, 14:08
|
geomety in STAR-CCM+ 4
|
#1 |
|
Member
Join Date: Mar 2011
Posts: 33
Rep Power: 15  |
Hello everybody,
i am using star-ccm+ 6 and 4 but in the version 4 when i start a job there is not geometry, so i can not crate a geometry there for example i would like to create a pipe, but in version 6 when i start a new job there is a geometry so i can create a new geometry. can anyone help to tell how can i create geometry in star-ccm+4?? Regards, akar |
|
|
|
|
|
May 2, 2011, 17:27
|
|
#2 |
|
Senior Member
Join Date: Apr 2009
Posts: 154
Rep Power: 16 |
Geometry creation was introduced in version 5. If you must, you can create in version 6, export surface, and import into version 4.
|
|
|
|
|
|
|
November 18, 2011, 08:43
|
|
#3 |
|
New Member
jai ganesh
Join Date: Dec 2010
Posts: 1
Rep Power: 0 |
I think starccm 4 doesn't have inbuilt geometry tool, you need to use "Starccm CAD Design" and import to starccm+ for simulation
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
| Fluent Vs Star CCM | firda | Main CFD Forum | 3 | February 26, 2011 02:51 |
| [Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
| error in star ccm | maurizio | Siemens | 3 | October 16, 2007 05:17 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Linear Mode
