Tank Mixing Problem

davidleinster · April 5, 2013, 08:14

I am looking for a freelancer to assist us with design verfication of a tank mixing system. Two tall tanks have a recirculating mixing system installed via extracting fluid from the base of the tanks through 3 nozzles at various positions and orientations in the tank. We need someone to assist with CFD modelling of the system (constant temperature assumed) to verify that good mixing is occuring. A series of velocity plots developed in suitable CFD software would be an appropriate deliverable. No large reporting requirements other than the pictures.

Our budget is limited to $500 as this is an additional unplanned expense in the project.

ah_eshtiaghi · April 5, 2013, 09:21

I am a CFD engineer working at western mass. I can give you a hand on this project if you send me the tank drawing and sizes.
Regards

davidleinster · April 6, 2013, 16:54

Thanks for all of the replies and private messages, this project is now closed.

David

April 5, 2013, 08:14	Tank Mixing Problem	#1
davidleinster New Member David Leinster Join Date: Apr 2013 Posts: 2 Rep Power: 0	I am looking for a freelancer to assist us with design verfication of a tank mixing system. Two tall tanks have a recirculating mixing system installed via extracting fluid from the base of the tanks through 3 nozzles at various positions and orientations in the tank. We need someone to assist with CFD modelling of the system (constant temperature assumed) to verify that good mixing is occuring. A series of velocity plots developed in suitable CFD software would be an appropriate deliverable. No large reporting requirements other than the pictures. Our budget is limited to $500 as this is an additional unplanned expense in the project.

April 6, 2013, 16:54	Project closed	#3
davidleinster New Member David Leinster Join Date: Apr 2013 Posts: 2 Rep Power: 0	Thanks for all of the replies and private messages, this project is now closed. David

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
about the top of the mixing tank	boh_tea	FLUENT	7	August 21, 2010 03:58
Mixing model with rotating impeller problem	201	CFX	10	May 14, 2010 11:59
Modelling mixing tank using MRF	Adi	FLUENT	6	November 4, 2009 00:28
help about modeling A MIXING TANK	hmasenger	CFX	2	April 13, 2009 15:21
Open tank problem	weechristo	FLUENT	1	April 10, 2009 13:40

April 5, 2013, 09:21		#2
ah_eshtiaghi New Member Amir Eshtiaghi Join Date: Apr 2009 Location: Massachusetts, USA Posts: 8 Rep Power: 6	I am a CFD engineer working at western mass. I can give you a hand on this project if you send me the tank drawing and sizes. Regards