|January 21, 2014, 08:10||
Need some assistance in modelling
Join Date: Jan 2014
Posts: 9Rep Power: 4
Project details below
To study and compare the spray length, cone angle of the spray and droplet size inside the cylinder of petrodiesel and biodiesel.
. 3 orifices at 120° each
. At the end of compression,
Air pressure = 30-40 bar at 250° C
Fuel pressure = 250 bar
Arrangement : A cylinder arrangement of a diesel engine with the two valves in the closed position. An injector is placed in the middle vertically, the nozzle tip has 3 orifices placed at 120° each. Orifice dia being 0.6mm.
All the dimensions of the cylinder arrangement to be taken according to any specific standard.
|January 21, 2014, 11:36||
Join Date: Jul 2013
Posts: 31Rep Power: 5
Hi-Tech Engineering will be happy to assist you in your project.
Please visit :
Hi-Tech: Engineering Services - CAE, FEA, CFD : http://bit.ly/Hi-Tech-CAE-FEA-CFD-Services
To view our services and case studies.
Our services are cost effective and we will be happy to get associated with your organization.
Looking forward to hear from you.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Assistance for modelling unsteady supersonic flow in FLUENT||SATISH A.V||FLUENT||11||October 1, 2014 22:36|
|kOmegaSST without turbulence modelling of the flow around geometry||CFDnewbie147||OpenFOAM Running, Solving & CFD||7||December 5, 2013 08:29|
|error message||cuteapathy||CFX||14||March 20, 2012 07:45|
|Advice on multi-phase flow modelling||Martin||Main CFD Forum||3||October 14, 2008 05:16|
|Unsteady modelling technique?||Carlos||FLUENT||0||September 26, 2008 11:37|