|
[Sponsors] |
January 21, 2014, 07:10 |
Need some assistance in modelling
|
#1 |
New Member
Join Date: Jan 2014
Posts: 9
Rep Power: 12 |
Project details below
To study and compare the spray length, cone angle of the spray and droplet size inside the cylinder of petrodiesel and biodiesel. . 3 orifices at 120° each . At the end of compression, Air pressure = 30-40 bar at 250° C Fuel pressure = 250 bar Arrangement : A cylinder arrangement of a diesel engine with the two valves in the closed position. An injector is placed in the middle vertically, the nozzle tip has 3 orifices placed at 120° each. Orifice dia being 0.6mm. All the dimensions of the cylinder arrangement to be taken according to any specific standard. |
|
January 21, 2014, 10:35 |
|
#2 |
New Member
Join Date: Jan 2014
Posts: 2
Rep Power: 0 |
Dear if you need simulations using Ansys CFX. I can help you. you can contact me with details.
|
|
January 21, 2014, 10:36 |
|
#3 |
New Member
Hemen Shah
Join Date: Jul 2013
Posts: 29
Rep Power: 12 |
Hello Naresh,
Hi-Tech Engineering will be happy to assist you in your project. Please visit : Hi-Tech: Engineering Services - CAE, FEA, CFD : http://bit.ly/Hi-Tech-CAE-FEA-CFD-Services To view our services and case studies. Our services are cost effective and we will be happy to get associated with your organization. Looking forward to hear from you. Regards Hemen Shah. www.hitechos.com hemen.shah@hitechos.com. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Assistance for modelling unsteady supersonic flow in FLUENT | SATISH A.V | FLUENT | 11 | October 1, 2014 22:36 |
kOmegaSST without turbulence modelling of the flow around geometry | CFDnewbie147 | OpenFOAM Running, Solving & CFD | 7 | December 5, 2013 07:29 |
error message | cuteapathy | CFX | 14 | March 20, 2012 06:45 |
Advice on multi-phase flow modelling | Martin | Main CFD Forum | 3 | October 14, 2008 05:16 |
Unsteady modelling technique? | Carlos | FLUENT | 0 | September 26, 2008 11:37 |