 |
 |
 |
|
|
|
[Sponsors] | ||||
Triggering transition onset of the boundary layer at a specified location |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 29, 2012, 21:59
|
Triggering transition onset of the boundary layer at a specified location
|
#1 |
|
Member
Darren Leong
Join Date: Dec 2010
Posts: 64
Rep Power: 15  |
Hi CFXers,
I'm trying to figure out how to trip the boundary layer from laminar to turbulent at a specific location of a torpedo shaped body. In scaled model testing, they have a hama strip located ~5% of the body length from the nosetip to trip the boundary layer. However, I have yet to figure out how to replicate this in CFX, as in triggering the transition at the specified location. At the moment, I'm exploring the SST transition model for this which allow both laminar and turbulent boundary layer modelling on the body. Any advice is deeply appreciated. Regards, Leong |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| simulation of subharmonic resonance in boundary layer transition | hadesmajesty | Main CFD Forum | 0 | July 30, 2010 09:00 |
| Airfoil Boundary Layer Transition Point | sas | FLUENT | 1 | March 15, 2007 11:32 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
| Boundary layer transition over a flat plate | shraman | Main CFD Forum | 1 | May 12, 2005 04:55 |
| New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 06:18 |
Linear Mode
