|July 2, 2012, 03:07||
Problem with setting configuration controls
Join Date: Jul 2012
Posts: 2Rep Power: 0
I need some help with regards to the worked example chapter 23 oscillating plate with two way fluid structure interface.
I have modified my project from there and in mine project, I have a large deformation and hence I would need to remesh but in order to do so, I need to set some configuration settings based on http://www.edr.no/blogg/ansys_blogge...cfx_re_meshing
But I am unable to add any configuration settings at all.
Please help me, looking forward to any replies.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem setting C_MU_T with DEFINE_ADJUST||Andy||FLUENT||2||July 30, 2014 05:05|
|Problem in setting porosity region for rhoPorousSimpleFoam||run_cfd||OpenFOAM Pre-Processing||1||May 31, 2011 09:02|
|Discretization problem in Solution controls||Tamm||FLUENT||0||July 15, 2005 07:07|
|Problem setting C_MU_T with DEFINE_ADJUST||sarah_ron||FLUENT||1||February 24, 2005 13:11|
|Help setting up combustor problem||Tom||FLUENT||0||February 5, 2005 02:20|