Interpolation warning message
 

Dear all,
I am doing fan simulation to develop performance curve. In the simulation, I am getting some warning message while interpolation. I don't know what they meant and the significance of the same. I have given that message in the below link. I need your help..
http://www.cfd-online.com/Forums/att...1&d=1342833086
Thanks in advance.

I am not familiar with that message - but it does not sound serious. I would write the initial condition out (as a results file at timestep zero) and check the interpolation of the initial condition is correct. If it looks good then you have no problem.

Hi glenn,
you were right. Thank you.