Interpolation warning message

ayothicfd · July 20, 2012, 21:13

Dear all,
I am doing fan simulation to develop performance curve. In the simulation, I am getting some warning message while interpolation. I don't know what they meant and the significance of the same. I have given that message in the below link. I need your help..
http://www.cfd-online.com/Forums/att...1&d=1342833086
Thanks in advance.

ghorrocks · July 21, 2012, 06:02

I am not familiar with that message - but it does not sound serious. I would write the initial condition out (as a results file at timestep zero) and check the interpolation of the initial condition is correct. If it looks good then you have no problem.

ayothicfd · July 23, 2012, 22:32

Hi glenn,
you were right. Thank you.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Native Meshers: blockMesh	2	March 14, 2012 10:56
latest OpenFOAM-1.6.x from git failed to compile	phsieh2005	OpenFOAM Bugs	25	February 9, 2010 04:37
Version 15 on Mac OS X	gschaider	OpenFOAM Installation	120	December 2, 2009 10:23
Compilation errors in ThirdPartymallochoard	feng_w	OpenFOAM Installation	1	January 25, 2009 06:59
Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Native Meshers: blockMesh	10	April 2, 2007 14:00

July 21, 2012, 06:02		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 6,980 Rep Power: 59	I am not familiar with that message - but it does not sound serious. I would write the initial condition out (as a results file at timestep zero) and check the interpolation of the initial condition is correct. If it looks good then you have no problem.

July 23, 2012, 22:32		#3
ayothicfd New Member Ayothi Ramanathan Join Date: Sep 2011 Posts: 28 Rep Power: 3	Hi glenn, you were right. Thank you.