Interpolation warning message

ayothicfd · July 20, 2012, 21:13

Dear all,
I am doing fan simulation to develop performance curve. In the simulation, I am getting some warning message while interpolation. I don't know what they meant and the significance of the same. I have given that message in the below link. I need your help..
http://www.cfd-online.com/Forums/att...1&d=1342833086
Thanks in advance.

ghorrocks · July 21, 2012, 06:02

I am not familiar with that message - but it does not sound serious. I would write the initial condition out (as a results file at timestep zero) and check the interpolation of the initial condition is correct. If it looks good then you have no problem.

ayothicfd · July 23, 2012, 22:32

Hi glenn,
you were right. Thank you.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
latest OpenFOAM-1.6.x from git failed to compile	phsieh2005	OpenFOAM Bugs	25	February 9, 2010 04:37
Version 15 on Mac OS X	gschaider	OpenFOAM Installation	113	December 2, 2009 10:23
Compilation errors in ThirdPartymallochoard	feng_w	OpenFOAM Installation	1	January 25, 2009 06:59
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00

July 21, 2012, 06:02		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	I am not familiar with that message - but it does not sound serious. I would write the initial condition out (as a results file at timestep zero) and check the interpolation of the initial condition is correct. If it looks good then you have no problem.

July 23, 2012, 22:32		#3
ayothicfd New Member Ayothi Ramanathan Join Date: Sep 2011 Posts: 28 Rep Power: 14	Hi glenn, you were right. Thank you.