CFX from Ansys Workbench 14 dont update
 

Hello,

i have a problem. I set up a workbench project running CFX simulations.
When I add parameters and select update all design points, it wont start at all. When I click on solution and select update, it runs. when I select update all design points, i get a message, that all design points are up to date. SStrangely enough its a new project not using an previous information or simulation and there were no other design points ran previously.

Btw. I experienced this problem only in WB14.

Thank you for help
Vit

Hello,

is it only my experience with WB14?

Thank you

I have experienced the same issue- unfortunately I havent figured out what has gone wrong.

I had the parameters working fine in v12.1, but the same models wont work in either v13 or v14...

If anyone has any solutions to this it would be great...