CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   rotor37 mesh (

Ehsan01 October 12, 2012 11:46

rotor37 mesh
I want to use sst model in ansys cfx12 , for simulation of rotor 37 hub and shroud end wall boundary layer, I examined several different meshes and boundary conditions but I couldn’t obtain accurate answer in comparison with the AGARD experimental result and there are very error in span above 60% and near the tip (with 0.0356 cm tip clearance).
It is wondering if you could guide me and send the bladeGen and mesh file to my email address. (
Thanks a lot

All times are GMT -4. The time now is 14:51.