 |
 |
 |
|
|
|
[Sponsors] | ||||
October 12, 2012, 11:46
|
rotor37 mesh
|
#1 |
|
New Member
Ehsan
Join Date: Oct 2012
Posts: 1
Rep Power: 0  |
Hello
I want to use sst model in ansys cfx12 , for simulation of rotor 37 hub and shroud end wall boundary layer, I examined several different meshes and boundary conditions but I couldn’t obtain accurate answer in comparison with the AGARD experimental result and there are very error in span above 60% and near the tip (with 0.0356 cm tip clearance). It is wondering if you could guide me and send the bladeGen and mesh file to my email address. (airo_1365@yahoo.com) Thanks a lot Last edited by Ehsan01; October 29, 2012 at 07:07. |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 39 | June 5, 2013 19:02 |
| [ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
| snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Native Meshers: snappyHexMesh and Others | 2 | March 27, 2011 21:11 |
| Meshing aifoil in ICEM | student123a | ANSYS Meshing & Geometry | 13 | December 8, 2010 10:40 |
| 2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 04:49 |
Linear Mode
