is it possible to set a Monitorpoint in a moving body (Flap open at a safety valve), so that i can display the offset during/after the transient simulation?
Monitor the areaAve(x)@some pertainent area of the flap? (Or y or z).
If you set up a good area (or have a mesh region that is good) you should be able to monitor how your flap moves.
I attached a picture...
hm, I can't choose an area at the flap.
Problem is: the flap opens arround a center of rotation out of the flap!
if I measure: minVal(Total Mesh Displacement Y)@FLAP and
maxVal(Total Mesh Displacement Y)@FLAP
than I get two different values.
What I need is a kind of point at the flap (best in the middle, see picture)
anybody an idea?
|All times are GMT -4. The time now is 07:29.|