 |
 |
 |
|
|
|
[Sponsors] | ||||
December 11, 2012, 14:02
|
Initial Meridional Configuration Dialog
|
#1 |
|
New Member
Samuel J. Hund
Join Date: Dec 2012
Posts: 2
Rep Power: 0  |
I am designing an axial pump using bladeGen. The dimensions have changed (Hub and shroud diameters, blade angles, etc.) Is there a way to reopen the Initial Meridional Configuration Dialog or another quick way to change these variables all at once without redoing the entire workbench. I would be satisfied with just deleting the current blade (within bladeGen and starting over). Moving the points by hand tends to crash the software since these are all large changes.
|
|
|
|
|
 |
| Tags |
| bladegen, cfx |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 121 | March 7, 2013 17:21 |
| pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 2 | January 28, 2013 11:45 |
| High Courant Number @ icoFoam | Artex85 | OpenFOAM Running, Solving & CFD | 9 | January 3, 2012 08:06 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Linear Mode
