CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   How to specify a polyline or plane in CFX Expression Language (CEL) in CFX-Pre? (http://www.cfd-online.com/Forums/cfx/112731-how-specify-polyline-plane-cfx-expression-language-cel-cfx-pre.html)

francis1 February 4, 2013 08:13

How to specify a polyline or plane in CFX Expression Language (CEL) in CFX-Pre?
 
Hi,

Does anyone know how to specify a polyline or plane in CFX Expression Language (CEL) in CFX-Pre?

Thanks.

Regards
francis

singer1812 February 4, 2013 15:09

Best way for you to learn: start a recording session, make your line, stop your recording session and look at what CFX did.

francis1 February 4, 2013 21:17

Thanks for the reply. Other than this way, is there any code that can specify a location (e.g. point, polyline, plane) in CEL CFX-PRE?

singer1812 February 5, 2013 18:36

Sorry, didnt read your question correctly. You need this in Pre?

What are you trying to do? You can create a source point in pre.

francis1 February 6, 2013 09:30

Yes, for a specific point, putting a source point is helping. Thanks. How about putting a plane in CFX Pre? Is there a way to put a plane in CFX Pre?

Thanks.

Regards
Francis

singer1812 February 6, 2013 11:16

Not that I can think of. What are you trying to do? If you need a source in a plane, you probably can create a source in subdomain with mathmatical limits via CEL. If you are doing something else, you might have to build it into geometry.


All times are GMT -4. The time now is 16:18.