|February 18, 2013, 02:17||
the results of cfx-post to be initial condition of cfx-pre
Join Date: Feb 2013
Posts: 2Rep Power: 0
I got the result of cfx-post.
But I want to use this result as initial condition of cfx-pre not boundary
Help me ~
|February 18, 2013, 13:18||
Join Date: Dec 2009
Posts: 129Rep Power: 11
look at the cfx5solve --help
this will show you how to setup use of an -inifile.
There are rules about if the def or res file mesh is used, etc. So check the Ansys CFX solver documentation. All BCs are picked up from the def file.
If your mesh changes, you will need to use -interpolate this will ensure that the def file mesh will be used.
|February 18, 2013, 13:57||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
Look at the link below
New to ICEM CFD, try this document --> https://goo.gl/NEbygB
|February 18, 2013, 22:55||
Join Date: Nov 2011
Posts: 388Rep Power: 7
|Thread||Thread Starter||Forum||Replies||Last Post|
|Moving mesh||Niklas Wikstrom (Wikstrom)||OpenFOAM Running, Solving & CFD||122||June 15, 2014 06:20|
|transsonic nozzle with rhoSimpleFoam||Unseen||OpenFOAM Running, Solving & CFD||7||April 16, 2014 03:38|
|pimpleFoam: turbulence->correct(); is not executed when using residualControl||hfs||OpenFOAM Running, Solving & CFD||3||October 29, 2013 09:35|
|AMI speed performance||danny123||OpenFOAM||19||October 24, 2012 07:44|
|Error log||vw.cfd||OpenFOAM||6||August 7, 2009 05:44|