boundary conditions problem with mesh created in Icem

darazsbence · February 22, 2013, 17:39

Hello everyone,

I have a big problem: i created a mesh in Icem and then made a cfx5 output file but after i imported this file into cfx-pre and tried to determine boundary conditions i cannot select any edges or surfaces of my geometry therefore i cannot run solver properly. Please help me.

Thanks everyone in advance.

ghorrocks · February 23, 2013, 04:50

You need to define the boundary locations in ICEM as parts so CFX-Pre can recognise them.

darazsbence · February 23, 2013, 05:07

Thank you for your answer, but would you be more specific about how to do this?

ghorrocks · February 24, 2013, 04:02

This is basci ICEM stuff, do the ICEM tutorials. If they are not provided in the installation then download them from the ANSYS customer portal.

February 22, 2013, 17:39	boundary conditions problem with mesh created in Icem	#1
darazsbence New Member Darázs Bence Join Date: Feb 2013 Posts: 16 Rep Power: 13	Hello everyone, I have a big problem: i created a mesh in Icem and then made a cfx5 output file but after i imported this file into cfx-pre and tried to determine boundary conditions i cannot select any edges or surfaces of my geometry therefore i cannot run solver properly. Please help me. Thanks everyone in advance.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3	flakid	OpenFOAM Installation	16	December 28, 2010 08:48
ICEM Tetra mesh, Size reduction and Skewness problem	Catthan	ANSYS Meshing & Geometry	6	December 5, 2010 19:39
[Gmsh] Import problem	ARC	OpenFOAM Meshing & Mesh Conversion	0	February 27, 2010 10:56

February 23, 2013, 04:50		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,696 Rep Power: 143	You need to define the boundary locations in ICEM as parts so CFX-Pre can recognise them.

February 23, 2013, 05:07		#3
darazsbence New Member Darázs Bence Join Date: Feb 2013 Posts: 16 Rep Power: 13	Thank you for your answer, but would you be more specific about how to do this?

February 24, 2013, 04:02		#4
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,696 Rep Power: 143	This is basci ICEM stuff, do the ICEM tutorials. If they are not provided in the installation then download them from the ANSYS customer portal.