help on phase change model needed

richard2000 · March 1, 2013, 11:50

I am doing a melting/solidification model using homogeneous binary mixture in CFX. I specified the material specific reference enthalpy per the latent heat and the momentum source in terms of Darcy equation for porous media as a function of velocity and mass fraction. The results I got always show a very low flow velocity on the order of about 1mm/s rather than about 100 mm/s in reality. I tried different momentum source terms or even nothing at all, and the flow velocity increases slightly but still on the order of mm/s. I have found papers using similar models although no details are inclded. What could I have done wong? I have been struggling with this for a long time. Your help is highly appreciated!

Best regards,

Richard

ghorrocks · March 3, 2013, 05:31

Melting/solidification models are very complex and hard to run. There is no way based on the sketchy information you describe anybody can debug that. In fact debugging complex models like this takes a long time and a lot of patience and skill.

Other than the general advice here I cannot help much: http://www.cfd-online.com/Wiki/Ansys..._inaccurate.3F

March 1, 2013, 11:50	help on phase change model needed	#1
richard2000 New Member Join Date: Sep 2010 Posts: 6 Rep Power: 15	I am doing a melting/solidification model using homogeneous binary mixture in CFX. I specified the material specific reference enthalpy per the latent heat and the momentum source in terms of Darcy equation for porous media as a function of velocity and mass fraction. The results I got always show a very low flow velocity on the order of about 1mm/s rather than about 100 mm/s in reality. I tried different momentum source terms or even nothing at all, and the flow velocity increases slightly but still on the order of mm/s. I have found papers using similar models although no details are inclded. What could I have done wong? I have been struggling with this for a long time. Your help is highly appreciated! Best regards, Richard

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Thermal phase change set up problem	Danial Q	Main CFD Forum	1	July 10, 2014 14:41
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
phase change with CFX	aximefu	CFX	5	March 28, 2012 03:38
Help needed to model gas-solids flow	Juliana P	FLUENT	3	September 21, 2005 09:42
thermal phase change question	CFDflying	CFX	1	February 18, 2004 04:10

March 3, 2013, 05:31		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	Melting/solidification models are very complex and hard to run. There is no way based on the sketchy information you describe anybody can debug that. In fact debugging complex models like this takes a long time and a lot of patience and skill. Other than the general advice here I cannot help much: http://www.cfd-online.com/Wiki/Ansys..._inaccurate.3F