|March 5, 2013, 02:34||
ask for help :about cfx turbogrid
Join Date: Mar 2013
Posts: 3Rep Power: 4
i want to form a stator .but when i put in the profile ,it gives a warn:
First blade profile is not defined as a hub tip and is too far (0.0945101 of span) from the
hub for reliable surface intersection.Surface extension factor will be adjusted accordingly, however application may become unreliable.
Last blade profile is not defined as a shroud tip and is too far (0.858225 of span) from the
shroud for reliable intersection. Must be at least 0.858235 of span. "
i tried some ways ,but can't solve it .Can anybody help me about this question ?thank you！
|June 13, 2014, 08:14||
redefine hub coordinates with blade profile at 0% of span coordinates
Join Date: Mar 2014
Location: Lyon, France
Posts: 16Rep Power: 3
I think your blade profile at 0% of span is not corresponding to yourhub profile.
Do you try to redefine the hub profile in using the blade profile at 0% of span coordinates? and use 100% of span blade profile coordinates to redefine the shroud coordinates? (plus coordinates to define inlet and outlet domains)
I think my problem is similar:
Surfaces Blade_1_tr_low and Blade_1_sh_tip_rot do not intersect.
Keep me in the loop
|Thread||Thread Starter||Forum||Replies||Last Post|
|CFX Treatment of Laminar and Turbulent Flows||Jade M||CFX||10||December 11, 2015 20:52|
|Different flow pattern between OpenFOAM and CFX||AirS||OpenFOAM||0||January 12, 2010 08:08|
|heat generation in CFX||Ema||CFX||4||August 7, 2009 05:39|
|PhD using CFX||Rui||CFX||9||May 28, 2007 05:59|
|FSI using CFX and ANSYS||Bi Chang||CFX||2||May 10, 2005 04:47|