Return with error code 1
 

Hi Everyone,

I have a problem concerning error code 1 and don't know what to do. I would like to continue a SST run with and SSG so when I define my new run I select the . def file of the SSG setup and then check the box that says initial values and there I select the SST run .res file. I tried double precision too, but it would't work.

Seperatly, the SSG and the SST setup ran without any problem, I used the same mesh and boundary conditions, and only changed the turbulence model.

Thanks everyone in advance.

Looks like a problem setting initial conditions. The SSG model will not be getting the Reynolds stresses from the SST model initial conditions, so have a look at how these are defined.