Return with error code 1

darazsbence · March 30, 2013, 08:11

Hi Everyone,

I have a problem concerning error code 1 and don't know what to do. I would like to continue a SST run with and SSG so when I define my new run I select the . def file of the SSG setup and then check the box that says initial values and there I select the SST run .res file. I tried double precision too, but it would't work.

Seperatly, the SSG and the SST setup ran without any problem, I used the same mesh and boundary conditions, and only changed the turbulence model.

Thanks everyone in advance.

ghorrocks · April 1, 2013, 18:40

Looks like a problem setting initial conditions. The SSG model will not be getting the Reynolds stresses from the SST model initial conditions, so have a look at how these are defined.

March 30, 2013, 08:11	Return with error code 1	#1
darazsbence New Member Darázs Bence Join Date: Feb 2013 Posts: 16 Rep Power: 13	Hi Everyone, I have a problem concerning error code 1 and don't know what to do. I would like to continue a SST run with and SSG so when I define my new run I select the . def file of the SSG setup and then check the box that says initial values and there I select the SST run .res file. I tried double precision too, but it would't work. Seperatly, the SSG and the SST setup ran without any problem, I used the same mesh and boundary conditions, and only changed the turbulence model. Thanks everyone in advance.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[PyFoam] Why no non-zero return codes?	Horus	OpenFOAM Community Contributions	3	May 8, 2012 10:25
return in udf	wlt_1985	FLUENT	5	September 21, 2011 04:35
Error in CFX Solver	Leuchte	CFX	5	November 6, 2010 06:12
Missing math.h header	Travis	FLUENT	4	January 15, 2009 11:48
REAL GAS UDF	brian	FLUENT	6	September 11, 2006 08:23

April 1, 2013, 18:40		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,697 Rep Power: 143	Looks like a problem setting initial conditions. The SSG model will not be getting the Reynolds stresses from the SST model initial conditions, so have a look at how these are defined.