|April 17, 2013, 09:00||
Creating polyline from surface intersection
Join Date: Mar 2013
Posts: 41Rep Power: 4
Now that I am trying to post-process some results I can't figure out how to create polylines that are not on boundaries (unless you use a csv file).
Does anyone have a clue on how to create polylines by intersecting an interface boundary and a surface of revolution? ANoher question would be how to control the chart count? Apparently the default is 50 points, but sometimes I get 70...
Here's a pic to illustrate. Basically I want to mid-section the annulus!
|April 17, 2013, 21:36||
Join Date: Dec 2009
Posts: 129Rep Power: 11
you will most likely get more information and flexibility using the Turbo tab in CFD-Post.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Comsol (4.3): convert parametric surface into block?||sgalaz||Main CFD Forum||0||November 9, 2012 10:20|
|killed "snappyHexMesh"||parkh32||OpenFOAM Pre-Processing||2||April 8, 2012 17:12|
|How can I define a intersection surface with ICEM?||BEN EZZEDDINE Anouar||CFX||0||November 15, 2005 07:05|
|creating volume from a surface file for CFD||Amir||Main CFD Forum||0||December 24, 2002 03:08|
|CFX4.3 -build analysis form||Chie Min||CFX||5||July 12, 2001 23:19|