discontinuity rotor stator...going crazy..

kr2552 · May 10, 2013, 04:36

As u can see.... there is no relationship between
1st part(stationary air part) ,2nd part(rotor) ,3rd part(stator)

i set up frozen rotor(value 1) and i made interface each connection between parts... but in view as u can see it doesn't work well...

what can i do ...could u tell me how to doit?...

ghorrocks · May 10, 2013, 23:42

Looks like you are plotting velocity. Try plotting velocity in stationary frame. (Have to write a FAQ on this one day, I think I have pointed this out to people about 5 times this week alone....)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Discontinuity due to Interior edge !!!	Babak.Mazhari	FLUENT	0	April 26, 2013 22:19
div(grad) not equal to laplacian close to a discontinuity	gtg258f	OpenFOAM	10	December 6, 2012 05:58
Rotor stator problem: Discontinuity across the interface	Bubka	CFX	2	November 11, 2009 07:57
Autogrid: discontinuity of 90 degrees in shroud	Eric Joubarne	NUMECA	1	July 21, 2009 04:34
Stepwise Discontinuity problem	Alan Kang	Main CFD Forum	1	February 22, 2000 23:46

May 10, 2013, 23:42		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 6,940 Rep Power: 59	Looks like you are plotting velocity. Try plotting velocity in stationary frame. (Have to write a FAQ on this one day, I think I have pointed this out to people about 5 times this week alone....)