CFX Post Calculating Data in a 60° segment of a turbocharger

Ckern · June 22, 2014, 04:53

Hello,

i have simulated a turbocharger (inlet,impeller,diffusor and volute) - the impeller has 6 main- and 6 splitterblades and i used the frozen rotor model.
I want to know if it is possible to calculate data in just one Impellerpassage in CFX Post, means 60° grad segment with one main- and one splitterblade, and make some "pictures" that shows only the one impellerpassage with diffusor and volute part behind the passage.
I tried the graphic with clip planes, but i cant use two clip planes simultaneous.

Thank you
Ckern

ghorrocks · June 22, 2014, 07:19

Generate a user surface or volume from the impellor domain, defined by theta angle or something like that. Then you can show the 60° segment of impellor and the full volute and other bits.

June 22, 2014, 04:53	CFX Post Calculating Data in a 60° segment of a turbocharger	#1
Ckern New Member Christoph Join Date: May 2014 Posts: 4 Rep Power: 11	Hello, i have simulated a turbocharger (inlet,impeller,diffusor and volute) - the impeller has 6 main- and 6 splitterblades and i used the frozen rotor model. I want to know if it is possible to calculate data in just one Impellerpassage in CFX Post, means 60° grad segment with one main- and one splitterblade, and make some "pictures" that shows only the one impellerpassage with diffusor and volute part behind the passage. I tried the graphic with clip planes, but i cant use two clip planes simultaneous. Thank you Ckern

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help on adjusting of CFX data to test data	Mehdi534	CFX	0	September 11, 2012 04:41
vertex post data	george	Siemens	1	January 6, 2007 14:31
How to save cell set post data in to a file	Negin	Siemens	1	January 27, 2006 03:41
How to make data file for matlab from CFX?	cfxbeginner	CFX	4	October 19, 2002 07:56
creating expresions in cfx build or cfx post	alex	CFX	1	August 22, 2002 13:01

June 22, 2014, 07:19		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	Generate a user surface or volume from the impellor domain, defined by theta angle or something like that. Then you can show the 60° segment of impellor and the full volute and other bits.